Recon Accessories - Recon 264200WH LED Bulbs

Recon's new LED bulbs feature extremely low power consumption, have built-in current limiting resistors, generate practically no heat and boast a longer life expectancy than any other automotive LED bulb currently available. Recon LED bulbs have an average life expectancy of up to 80,000 Hours. LED bulbs may cause some newer vehicles to indicate a bulb is burnt out (Because Of Their Low Power Consumption). Some cars indicate this by increasing the flash rate of the turn signals, some turn on a bad bulb indicator. This can be remedied with our Load Resistors wired across the turn signal bulbs to simulate a filament bulb load. This 6 Ohm, 50 Watts resistors can be connected across the turn signal bulbs to simulate the load of a regular filament bulb (2 Ampere load). This will solve LED related turn signal problems such as hyper flashing or burnt out bulb indications. This LED Load Resistor can be use with most signal or brake light which uses single or dual filament LED light bulbs. Connection Instructions: Using included splice taps, connect one wire to ground and the other wire to the turn or brake hot wire. Splice taps allow for installation without cutting your turn signal wires.